Question 1

Which two security features are available when implementing NTP? (Choose two.)

Accepted Answer

Correct answer: DE

Question 2

An engineer must implement a configuration to allow a network administrator to connect to the console port of a router and authenticate over the network. Which
command set should the engineer use?

Accepted Answer

Correct answer: B

Question 3

A network administrator wants to install new VoIP switches in a small network closet but is concerned about the current heat level of the room. Which of the
following should the administrator take into consideration before installing the new equipment?

Accepted Answer

This is because the direction of airflow within the switches can affect the heat level of the room, as the switches can either exhaust or intake hot air from the
environment. The network administrator should take into consideration the direction of airflow within the switches before installing the new equipment, and ensure
that the switches are aligned in the same direction and have enough space for ventilation. The network administrator should also avoid mixing switches with
different airflow directions, as this can create a hot spot and reduce the cooling efficiency. The source of this answer is the Cisco ENCOR v1.1 course, module 2,
lesson 2.1: Implementing Device Hardening.

Question 4

An engineer must contigure a rou'.er to allow users to run specHic configuration commands by validating the user against the router database. Which configuration
must be applied?

Accepted Answer

Correct answer: C

Question 5

Refer to the exhibit.

(747 New Questions)
An engineer configures a new WLAN that will be used for secure communications; however, wireless clients report that they are able to communicate with each
other. Which action resolves this issue?

Accepted Answer

Correct answer: D

Question 6

By default, which virtual MAC address does HSRP group 30 use?

Accepted Answer

Correct answer: B

Question 7

A customer has 20 stores located throughout a city. Each store has a single Cisco access point managed by a central WLC. The customer wants to gather
analysis for users in each store. Which technique supports these requirements?

Accepted Answer

Correct answer: B

Question 8

A network engineer must configure a switch to allow remote access for all feasible protocols. Only a password must be requested for device authentication and all
idle sessions must be terminated in 30 minutes. Which configuration must be applied?

(747 New Questions)

Accepted Answer

Correct answer: C

Question 9

An engineer must configure router R1 to validate user logins via RADIUS and fall back to the local user database if the RADIUS server is not available. Which
configuration must be applied?

Accepted Answer

Correct answer: C

Question 10

Refer to the exhibit.
Which two commands ensure that DSW1 becomes the root bridge for VLAN 10 and 20? (Choose two.)

Accepted Answer

Correct answer: DE