Question 1

What must a network administrator implement in order to run an NAE script on an AOS-CX switch?

Accepted Answer

Correct answer: D

Question 2

What is correct regarding rate limiting and egress queue shaping on AOS-CX switches?

Accepted Answer

you could apply egress queue shaping to the high priority queues to prevent starvation of low priority queues. Egress queue shaping allows you to apply a
maximum bandwidth to a priority queue, as well as a burst size. The port buffers excess traffic up to the burst size and sends the buffered traffic at the max rate,
smoothing out bursts while also preventing the high priority queue from exceeding its maximum rate and starving out lower priority queues.

Question 3

An administrator is managing a VSX pair of AOS-CX switches An administrator configures the following on the primary AOS-CX switch:

Accepted Answer

Correct answer: D

Question 4

A company requires access by all users, guests, and employees to be authenticated. Employees will be authenticated using 802.1X, whereas guests will be
authenticated using captive portal. Which type of
authentication must be configured on an AOS-CX switch ports where both guests and employees connect?

Accepted Answer

Employees use 802.1x
The Aruba guest solution uses MAC-auth.
The Portal is not configured on the switch port.

Question 5

What is a concept associated with PIM sparse mode (SM)?

Accepted Answer

https://www.youtube.com/watch?v=PhzMcUcS6UA

Question 6

Which protocol does NetEdit use to discover devices in a subnet during the discovery process?

Accepted Answer

Correct answer: A

Question 7

An administrator wants to implement a virtual switching technology that implements a single control-plane solution. Which S-CX switches would meet these
criteria?

Accepted Answer

Correct answer: C

Question 8

Examine the following AOS-CX configuration:
Based on this configuration, which statement is correct regarding IoT traffic?

Accepted Answer

Correct answer: B

Question 9

An administrator implements interim accounting for guest users so that ClearPass can track the amount of bandwidth that guests upload and download. Guests
that abuse bandwidth consumption should be disconnected from the network. The administrator configures the following on the AOS-CX access switches:
After performing this configuration, the administrator notices that guest users that have exceeded the guest bandwidth limit are not being disconnected. Upon
further investigation, Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.
What is causing this issue?

Accepted Answer

Correct answer: A

Question 10

What is correct regarding policy-based routing?

Accepted Answer

Correct answer: A